Figure 4.3.1.3-1 Cabinet Wall Mount Kit Installation - LG-Nortel ipecs Installation Manual

IPECS Release 5
Hardware Description & Installation
Issue 5.0
Disassemble the hinges by separating the hinge body and removing the hinge pin.
Mount the separated hinge bodies, two to the Wall Mount bracket and two to the cabinet
using the M6 x 8 mm machine screws two (2) for each hinge body provided.
Use the Wall Mount kit to mark the location of four (4) mounting holes for the Wall Mount kit
as shown in Figure 4.3.1.3-1. Assure the Wall Mount holes are level and plum.
Drill four (4) 7 mm holes for the plastic wall anchors provided.
Fully Insert a wall anchor into the each of the four (4) holes, insert and tighten screws
leaving about 6 mm (¼-inch) exposed.
Place the Wall Mount kit on the four (4) screws and tighten the screws securely.
Insert the hinge pins and mount the cabinet to the Wall Mount kit by aligning the hinge
bodies with the hinge pins and lower into place.
Finally, mount the Cabinet Latch to the Wall Mount bracket and cabinet using the six M3 x 6
mm screws provided. The latch must be installed on the side opposite of the hinges.

Figure 4.3.1.3-1 Cabinet Wall Mount Kit Installation

52