Connect The Lens And Lighting - National Instruments NI 17xx Smart Getting Started

– 16 mm (part number 780026-01)
– 25 mm (part number 780027-01)
• Current controlled lights
– Back light (part number 780221-01)
– Ring light (part number 780222-01)
– Broad area linear light array (part number 780223-01)
– Spot light (part number 780224-01)
• Mounting brackets
– Tripod adapter plate (part number 780239-01)
– Panel mount (part number 780240-01)
• Accessories
– NI 17xx unshielded screw terminal breakout with 2 m
cable (part number 780261-01)
– NI Smart Camera I/O accessory (part number 780443-01)
Visit
ni.com
information about these and other products.

Connect the Lens and Lighting

Complete the following steps to connect a standard C-mount lens
and external lighting accessories to the NI Smart Camera.
1. Remove the lens cover from the smart camera.
2. Gently align the threads on the base of the lens with the threads
on the sensor opening, and twist clockwise until the lens is
securely attached.
Lighting
The NI Smart Camera offers two options for controlling a light—a
Direct Drive internal lighting controller, or 5 V TTL or 24 V
external strobe generation for use with a third-party lighting
controller. Refer to the NI 17xx Smart Camera User Manual for
information about using the smart camera with a light.
Note
on NI 1722 smart cameras. NI 1722 smart cameras
support only 5 V TTL or 24 V external strobe generation.
Getting Started with the NI 17xx
or contact the branch office nearest you for more
The Direct Drive lighting controller is not available
4 ni.com