Ni Smart Camera Power Requirements; Lighting Connector - National Instruments NI Vision 17 Series User Manual

NI Smart Camera Power Requirements

Caution
limited power source (LPS) supply. The power supply should bear the UL listed
mark, LPS. The power supply must meet any safety and compliance requirements for
the country of use.
The NI 17xx Smart Camera uses a nominal 24 VDC power source. The device accepts power
within the range of 24 V ±10% with an additional allowance for an AC peak of +5%. Refer to
Appendix A, Specifications, for complete power requirement specifications.

Lighting Connector

Figure 3-1 shows the lighting connector on the NI Smart Camera.
Caution
Do not connect any external voltage or current source to any pin on the lighting
connector.
Note The NI 1712/1732 do not offer the Direct Drive lighting controller. Do not
connect to the LED+ and LED- connectors on the NI 1712/1732.
Note The NI 1712 does not support strobe lighting. Do not connect to the strobe
connectors on the NI 1712.
1 LED- Output (Absent on the NI 1712/1732)
2 LED+ Output (Absent on the NI 1712/1732)
3 Ground Output
Note Additional/replacement plugs for use with the lighting connector, part
number 780260-01, are available from NI.
Use the NI 17xx Smart Camera only with a 24 VDC ±10%, UL listed,
All signals on the lighting connector are outputs from the smart camera.
Figure 3-1. NI Smart Camera Lighting Connector
1
2
GND
3
4
5V
5
24V
4 5 V TTL Strobe Output (Absent on the NI 1712)
5 24 V Strobe Output (Absent on the NI 1712)
NI 17xx User Manual
© National Instruments | 3-3