Connecting The Power Supply; Connecting To The Power And I/O Accessory For Isc-178X Smart Cameras; Connecting A Lens - National Instruments ISC-178 Series Getting Started Manual

Connecting the Power Supply

Complete the following steps to supply power to the ISC-178x.
1. Verify the power source is turned off.
2. Connect and secure the M12 connector of the power supply cable to the Power and I/O
connector on the smart camera.
3. If necessary, connect the power supply cable to the power supply.
4. Turn on the external power source.
When power is first applied to the ISC-178x, the Power and Status LEDs flash red once while
internal systems power up. The Power LED lights green when power is wired correctly.
Related Information
LED Indications on page 13
Connecting to the Power and I/O Accessory for
ISC-178x Smart Cameras
Complete the following steps to connect the ISC-178x to the Power and I/O Accessory for
ISC-178x Smart Cameras. Refer to the Power and I/O Accessory for ISC-178x Smart Cameras
User Manual for more information.
1. Verify the power source is turned off.
2. Connect and secure the M12 connector of the terminal block cable to the Power and I/O
connector on the smart camera.
3. Connect and secure the other end of the terminal block cable to the terminal block.
4. Connect any additional I/O signals necessary for your application to the appropriate
signal on the cable or terminal block.
5. Connect the power supply to the 24 V IN connector on the Power and I/O accessory.
6. If necessary, connect the power supply cable to the power supply.
7. Turn on the external power source.
Related Information
LED Indications on page 13

Connecting a Lens

1. Connect the lens to the ISC-178x housing and screw it in firmly.
2. Slide the lens cover over the lens and screw it into the ISC-178x housing until it is firmly
in place. The lens cover must be in place for IP67 conformity.
6 | ni.com | ISC-178x Getting Started Guide