Lighting Connector - National Instruments ISC-1762 User Manual

Lighting
One of the most important aspects of setting up your imaging environment is proper
illumination. Images acquired under proper lighting conditions make your image processing
software development easier and overall processing time faster. The following sections describe
how to use the Direct Drive lighting controller and the strobe outputs of the NI Smart Camera to
control a light.

Lighting Connector

Figure 4-1 shows the lighting connector on the NI Smart Camera.
Caution
Do not connect any external voltage or current source to any pin on the lighting
connector.
The NI 1722 does not offer the Direct Drive lighting controller. Do not
Note
connect to the LED+ and LED- connectors on the NI 1722.
1 LED- Output (Not Available on the NI 1722)
2 LED+ Output (Not Available on the NI 1722)
3 Ground Output
Note Additional/replacement plugs for use with the lighting connector, part
number 780260-01, are available from NI.
All signals on the lighting connector are outputs from the smart camera.
Figure 4-1. NI Smart Camera Lighting Connector
1
2
GND
3
5V
4
24V
5
4 5 V TTL Strobe Output
5 24 V Strobe Output
© National Instruments | 4-1
4