Connect The Power Supply And I/O; Power Only - National Instruments NI 17xx Smart Getting Started

Connect the Power Supply and I/O

To connect a power supply to the NI Smart Camera, complete the
steps listed in one of the following sections. Refer to the Power
Only section to connect the NI desktop power supply directly to the
smart camera with no additional I/O. Refer to the
Additional I/O
if your application requires I/O, such as a trigger signal.
Caution
listed, limited power source (LPS) supply. The power
supply will bear the UL listed mark, LPS. The power
supply must also meet any safety and compliance
requirements for the country of use.

Power Only

Refer to Figure 1 while completing the following steps to connect
the NI desktop power supply to the NI Smart Camera with no
additional I/O.
1 NI Smart Camera
Figure 1. Connecting the NI Smart Camera to the NI Desktop Power Supply
1. Connect and secure the 15-pin D-SUB connector on the NI
desktop power supply to the POWER-I/O connector on the
smart camera.
2. Plug the power supply power cord into the power supply.
3. Plug the power supply into an outlet.
When power is first applied to the smart camera, the POWER LED
flashes red for one second while internal systems power up. The
POWER LED then lights green when power is correctly wired to
the smart camera.
© National Instruments Corp.
section to connect a third-party power supply or
Use the smart camera only with a 24 VDC, UL
1
2
2 Power Supply
5 Getting Started with the NI 17xx
Power with