Factory Setup (Restore Factory Defaults); Create And Load Templates; Reboot System; Check The Revision Levels - 3M XT-1 Installation Manual

Configuration

Factory Setup (Restore Factory Defaults)

Create and Load Templates

Reboot System

Check the Revision Levels

Activate the Backup Intercom

Change the Microphone Preamp Gain

May 2008 – Revision 1.3
Page 46 of 62
Perform the following procedure to restore all of the configuration settings to the
factory default settings. This procedure should be performed only if the current
configuration and the saved installation settings are unusable.
Important Note:
By performing this procedure you will reset the system to the initial
configuration, making it impossible to revert to the settings that were saved
after installation.
1. Enter the configuration mode, see page 31.
15 Factory Setup
2. Select
3. Change the value of
You can save an entire base station configuration as a file on a PC and use the
file as a template for other base stations. You must be using a PC to use
templates.
Perform the following procedure to cleanly power down, then power up without
unplugging the system:
1. Enter the configuration mode, see page 31.
16 Reboot System
2. Select
3. Change the value of
4. Press .
Service
Perform the following procedure to view the revision levels and serial numbers
of your base station:
1. Enter the configuration mode, see page 31.
17 Revision Levels
2. Select
Many systems include a wired backup intercom system that can be used if the
main wireless system cannot be used. If your system has a backup intercom
system, perform the following steps to activate it:
•
Remove the base station cover.
•
Press and latch the two switches named "BACKUP INTERCOM."
The Mic Preamp Gain is the first stage of amplification from the microphone in
the order point. In order to optimize the base station to a specific site this level
must be precisely set.
To change the microphone preamp gain:
1. Lookup the microphone's output level at 1kHz sensitivity (see the
microphone's specifications).
2. Enter the configuration mode, see page 31.
.
Restore All Factory Settings
.
Power Cycle Complete System
.
3M™ Wireless Communication System Model XT-1
Yes
to .
Yes
to .
Installation Manual