Power Up - 3M XT-1 Installation Manual

Timer Module

Power Up

Run Mode Menu
3M™ Wireless Communication System Model XT-1
Installation Manual
There is one space along the bottom of the base station for the optional timer
module, which is a planned future option. Perform the following procedure to
install it.
1. Ensure that the base station is unplugged.
2. Remove the base station cover, see page 14.
3. Align the top of the timer module with the installation slot.
4. Slide the bottom edge of the timer module board between the back of
the base station and the two raised tabs.
5. Install and gently tighten the screw.
6. Carefully install the flat cable between the timer module board and the
base station board. The left-to-right pin order is the same on both
boards: the left pin on one corresponds to the left pin on the other.
After installation is complete, you can power up the system by plugging in the
base station transformer.
When the system is powered up and functioning normally, the Run mode menu
appears on the display. The following drawing shows the Run mode menu.
13:25 WED,NOV/16/2005 | MODE< ML/PTT >
NOISE REDUCTION [LOW] | LANE 2 <SPLIT>
GREETER PLAYING MSG 1 | VOLUME < DAY >
Navigating in the Base Station in Run Mode
To navigate the base station in Run mode you only need to use
the directional arrow buttons: up
remaining buttons function only in manager or installer configuration modes.
, down , left , and right
May 2008 – Revision 1.3
Installation
, , and
Enter Mode
. The
Page 29 of 62