Using Your Pouring Shield - KitchenAid KN1PS Instructions Manual

Using Your Pouring Shield

To Attach Pouring Shield:
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Attach bowl and flat beater, dough
hook or wire whip to the mixer. Lower
and lock the motor head.
4. From the front of the mixer, slide the
Pouring Shield over the bowl until the
shield is centered. The bottom rim of
the shield should fit inside the bowl.
To Use Pouring Shield:
1. For best results, rotate the shield so
that the motor head covers the
u-shaped gap in the shield. This will
position the pouring chute just to the
right of the attachment hub as you
face the mixer.
2. Pour ingredients into the bowl
through the pouring chute.
Pouring
Chute
To Scrape Bowl:
Note:
mixer is running.
Turn mixer off. Slide the Pouring Shield off
the bowl, lift the mixer head, and scrape.
To Clean Pouring Shield:
Wash the Pouring Shield in warm, soapy
water or place it in the top rack of your
dishwasher.
3
Do not scrape bowl while the