Using Your Pouring Shield - KitchenAid Artisan KSM150PS User Manual

ASSEMBLING YOUR TILT-HEAD STAND MIXER
To Operate Speed Control
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See page 15 for Speed
Control Guide.
To Lock Motor Head
1.
Make sure motor head is
completely down.
2.
Place locking lever in LOCK
position.
3. Before mixing, test lock by
attempting to raise head.
To Unlock Motor Head
1.
Place lever in UNLOCK position.
NOTE: Motor head should always be
kept in LOCK position when using mixer.

USING YOUR POURING SHIELD*

To Attach Pouring Shield
1. Turn speed control to OFF.
2.
Unplug Stand Mixer or
disconnect power.
3. Attach Flat Beater, Dough Hook,
or Wire Whip and bowl (see
page 1 1).
4. From the front of the mixer, slide
the Pouring Shield over the bowl
until the shield is centered. The
bottom rim of the shield should fit
within the bowl.
To Remove Pouring Shield
1.
Turn speed control to OFF.
2. Unplug Stand Mixer or
disconnect power.
3.
Lift the front of the Pouring Shield
clear of the bowl rim and
pull forward.
4.
Remove attachment and bowl.
* If Pouring Shield is included.
12
Speed Control
Lock
Pouring Chute
To Use Pouring Shield
1.
For best results, rotate the shield
so the motor head covers the "u"
shaped gap in the shield. The
pouring chute will be just to the
right of the attachment hub as you
face the mixer.
2.
Pour the ingredients into the bowl
through the pouring chute.
Unlock