Available Options
The following options can be ordered separately:
72-inch EIA standard cabinet, 19 inches wide
Redundant/replacement power supply
Power supply fan tray
Replacement fan tray for NAMs
Replacement baffle
FrameSaver SLV 9128 1-Slot Housing-to-Access Carrier Upgrade Instructions for
converting a 1-slot FrameSaver SLV 9128 for use in the access carrier
Contact your sales representative to order an option.
Before You Begin
Make sure you have:
A grounded SELV – 48 VDC source which has a disconnect device and
overcurrent protection
A clean, well-lit, and ventilated site that is free from environmental extremes
One-to-two feet of clearance for cable connections
Strain relief material for cable support
A large Phillips screwdriver to install the access carrier in a cabinet or rack
A small or medium Phillips screwdriver to install the I/O card filler panels and front
filler panels
A small, flat-blade screwdriver to install the I/O cards, cable connections, and
redundant power supply (if needed)
Contacted your network provider to coordinate installing the carrier and its
associated cards into the network
Safety Instructions
Refer to the Important Safety Instructions beginning on page 13.
2