Paradyne 9000 Series Installation Instructions Manual page 4

Installing in a Cabinet/Rack with Threaded Screw Holes
1. Use a screwdriver to install the screw loosely enough to allow the bracket keyhole
to drop under the screw head during installation. Use the 9th hole as shown on the
left side of the carrier. Use the 12th hole on the right side of the carrier.
9th Hole
Front of 19-Inch Carrier Cabinet
2. Place the access carrier against the front rail of the cabinet, allowing the installed
machine screws on each side to pass through the keyholes.
3. Lower the access carrier into place, allowing the keyholes to slide under the screw
heads. This positions and supports the access carrier correctly for installation of
the remaining machine screws.
4. Install the remaining machine screws at the top and bottom on each side of the
brackets and tighten them.
Mounting
Front Rail
Bracket
Keyhole
496-15131
4