Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Paradyne Manuals
  4. Power Supply
  5. 9000 Series
  6. Installation instructions manual

Paradyne 9000 Series Installation Instructions Manual

5-slot housing and framesaver 9000 series access carrier ac power supply
Hide thumbs Also See for 9000 Series:
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual See also: Instruction and Installation Manual
5-Slot Housing and
FrameSaver 9000 Series Access Carrier
AC Power Supply
Installation Instructions
Document Number 9000-A2-GN17-30
August 1998

Before You Begin

Both the 5-slot housing and the FrameSaver 9000 Series Access Carrier can hold up to
two power supplies. A second redundant power supply provides backup for the first.
Before you start your installation, be sure to review the following information.
CAUTION:
Refer installation of power supplies to qualified service personnel.
!
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal
operation. When performing installation procedures,
however, take proper static control precautions to
prevent damage to equipment. If you are not sure
of the proper static control precautions, contact
your nearest sales or service representative.

Package Contents

Verify that your package contains an ac power supply (see following specifications).
TM
1
496-15149

Advertisement

loading

Related Manuals for Paradyne 9000 Series

Summary of Contents for Paradyne 9000 Series

  • Page 1: Before You Begin

    August 1998 Before You Begin Both the 5-slot housing and the FrameSaver 9000 Series Access Carrier can hold up to two power supplies. A second redundant power supply provides backup for the first. Before you start your installation, be sure to review the following information.
  • Page 2 The following ac power supplies are available. Make sure that you have the correct one for your housing and application. NOTE: The 120 Vac power supply has a label to warn you to connect the supply only to a 100–120 Vac power source. Name/Feature...
  • Page 3 Universal Power Supply Technical Specifications for Universal Power Supply in Access Carrier Specification Rated Nominal Voltage Operating Voltage Range Rated Current Power Consumption (typical) 1 power supply installed 2 power supplies installed Keyed 97-15746 Criteria 100–240 Vac, 50/60 Hz 85–265 Vac, 50/60 Hz 4.0 amps...
  • Page 4 Installing the Initial Power Supply Install the initial power supply into the top slot. (Use the bottom slot for a second power supply, if desired.) 1. Remove power supply from its shipping box. Handle only by the top and bottom edges to avoid damaging the card.

  • Page 5: Installing The Redundant Power Supply

    The power I/O card is marked with a label indicating the proper voltage. 3. At the front of the housing, use the attached handle on the power supply to carefully slide the card into the bottom left slot towards the midplane until you feel it connect.

  • Page 6: Power-Up Verification

    1. Insert the IEC connector end of the power cord into the I/O card’s power IEC 320 inlet. 2. Insert the plug into an ac outlet. The power supply LED lights. Verification Checklist Did the green power supply LED light? If not, see...

  • Page 7: Troubleshooting

    The wall receptacle has no power. Check the wall receptacle power Power supply is not fully inserted into the housing. If you are still having problems with the power supply, contact your service representative. Removing the Power Cord When disconnecting a power cord from an installed power supply: 1.