Installation Instructions Document Number 9000-A2-GN1A-10 April 1998 Before You Begin The 2-slot housing can hold one power supply, which is already installed in the housing. Should you need to replace this power supply, be sure to review the following information. CAUTION: Refer installation of power supplies to qualified service personnel.
Install a replacement power supply using the following instructions. WARNING: Before you remove the power supply module, you must unplug the power cord from the power receptacle and from the rear of the housing before attempting to remove the module.
Page 3
4. Remove the current power supply by pulling on the handle. 496-15126 5. Remove the new power supply from its shipping box. Handle only by the top and bottom edges of the sheet metal bracket to avoid damaging it. 6. At the front of the housing, use the attached handle on the power supply to carefully slide the housing into the slot towards the midplane until you feel it connect.
Power supply is not fully inserted into the housing. Power supply is defective. If you are still having problems with the power supply, contact your service representative. Power Failure Recovery In cases of loss and restoration of nominal voltage conditions, this product automatically restores to service without manual intervention.