Power Steering Hoses; Replacing Light Bulbs; Headlight Bulb; Replacement Instructions - Hyundai 2001 Sonata Owner's Manual

NOTE:
Grinding noise from the power steering
pump may be heard immediately after the
engine is started in extremely cold condi-
tions (below - 4°F). In this case, if the noise
stops during warm up, there is no abnormal
function in the system. This is due to a
power steering fluid characteristic in ex-
tremely cold conditions.
Recommended Fluid
Use PSF-3 type fluid
NOTE:
Do not start the engine when the power
steering oil reservoir is empty.
G240A01A-AAT

POWER STEERING HOSES

It is suggested that you check the power steer-
ing hose connections for fluid leakage at regular
intervals. The power steering hoses should be
replaced if there is severe surface cracking,
scuffing or worn spots. Deterioration of the
hose could cause premature failure.
G250A01A-AAT
FOR MORE INFORMATION ABOUT
YOUR HYUNDAI
If you desire additional information about main-
taining and servicing your Hyundai, you may
purchase a factory Shop Manual at your Hyundai
dealer's parts department. This is the same
DO-IT-YOURSELF MAINTENANCE
manual used by dealership technicians and
while it is highly technical it can be useful in
obtaining a better understanding of your car
and how it works.
G260A01A-AAT

REPLACING LIGHT BULBS

Before attempting to replace a light bulb, be
sure the switch is turned to the "OFF" position.
The drawings show how to reach light bulbs so
they may be changed. Be sure to replace the
burned-out bulb with one of the same number
and wattage rating.
G270A02Y-AAT

HEADLIGHT BULB

Replacement instructions:

1. Allow the bulb to cool. Wear eye protection.
2. Always grasp the bulb by its plastic base,
avoid touching the glass.
3. Disconnect the power cord from the bulb
base in the back of the headlight.
4. Push the bulb spring for removing the head-
light bulb.
5. Remove the protective cap from the re-
placement bulb and install the new bulb by
matching the plastic base with the headlight
hole. Retighten the bulb spring and recon-
nect the power cord.
6. Use the protective cap and carton to dis-
pose of the old bulb.
7. Check for proper headlight aim.
WARNING:
The halogen bulb contains gas under pres-
G270A01Y
sure and if impacted could shatter, resulting
in flying fragments. Always wear eye pro-
tection when servicing the bulb. Protect the
bulb against abrasions or scratches and
against liquids when lighted. Turn on the
bulb only when installed in a headlight. Re-
G270A02Y
6-17