Hyundai 2001 Sonata Owner's Manual page 70

B910B01Y-AAT
1. POWER ON-OFF
/VOLUME CONTROL KNOB
The radio unit may be operated when the igni-
tion key is in the "ACC" or "ON" position. Press
and rotate the knob clockwise to switch the
radio unit on, and to increase the volume. Turn
the knob counterclockwise to reduce the vol-
ume, and to switch the radio unit off.
2. BAS (Bass Control)/BAL (Balance
Control) Knob
Press to pop the knob out and turn to the left or
right for the desired bass tone.
BAL (Balance Control)
Further pull the popped-up knob. Turn the con-
trol knob clockwise to emphasize right speaker
sound. (Left speaker will be attenuated) When
the control knob is turned counterclockwise, left
speaker sound will be emphasized. (Right
speaker sound will be attenuated).
3. TRE (Treble Control)
Press to pop the knob out and turn to the left or
right for the desired treble tone.
FAD (Fader Control) Knob
Further pull the popped-up knob and turn the
control knob clockwise to emphasize front
speaker sound. (Rear speaker sound will be
attenuated)
FEATURES OF YOUR HYUNDAI
When the control knob is turned counterclock-
wise, rear speaker sound will be emphasized.
(Front speaker sound will be attenuated).
4. TUNE (Manual) Select Button
Press the (+) side or (-) side to increase or to
decrease the frequency. With the button held
down for 0.5 sec. or more, the stop signal
(broadcasting radio wave) is ignored and chan-
nel selection continues.
SEEK Operation (Auto tuning)
Push the "TUNE" for over 1 second. When the
(+) side is pressed, the unit will automatically
tune to the next higher frequency and when the
(-) side is pressed, it will automatically tune to
the next lower frequency.
5. BAND Selector
Pressing the button changes the AM, FM1
and FM2 bands. The mode selected is dis-
played on LCD.
6. PRESET STATION SELECT Button
Six (6) stations for AM, FM and FM2 respec-
tively can be preset in the electronic memory
circuit on this unit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be pro-
grammed into the memory of the radio. Then,
by simply pressing the band select button and/
or one of the six station select buttons, you may
recall any of these stations instantly. To pro-
gram the stations, follow these steps:
o Press button to set the band for AM, FM,
and FM2.
o Select the desired station to be stored by
seek, scan or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
o Press the station select button for more than
two seconds. A select button indicator will
show in the display indicating which select
button you have depressed. The frequency
display will flash after it has been stored into
the memory. You should then release the
button, and proceed to program the next
desired station. A total of 18 stations can be
programmed by selecting one AM and one
FM station per button.
o When completed, any preset station may be
recalled by selecting AM, FM or FM2 band
and the appropriate station button.
1- 61