Non-Continuous Test - Innova CAN OBD2 Owner's Manual

NON-CONTINUOUS TEST

The Non-Continuous Test function retrieves and displays test results
for emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The Scan Tool does not perform non-continuous test, but
retrieves results from the most recently performed tests from
the on-board computer's memory. You may retrieve non-
continuous test results for only one test at any given time.
1. From the "Mode Selection Menu", use
the UP
necessary,
Continuous
ENTER/LD
The "Select Test" screen displays.
The
applicable to the vehicle under test.
Refer to the vehicle's service repair
manual for information related to
non-continuous tests.
If non-continuous tests are not
supported by the vehicle under test,
an advisory message shows on the
Scan Tool's display. Press the
ENTER/LD
the Mode Selection menu.
2. Use the UP
as necessary, to highlight the desired
test, then press the ENTER/LD
button.
3. A "One moment please. . ." message
diplays while the request is sent to the
vehicle's on-board computer.
4. When test results have been retrieved, data for the selected test will
show on the Scan Tool's display. The display shows the following
information:
Test ID number
Module ID number
Component ID number
Min or Max test limit
Only one test limit, either Min
or Max, is shown for any given
test.
Test Value and status
OBD2
and DOWN buttons, as
to highlight
Test, then press the
button.
screen shows
button to return to
and DOWN
Additional Tests
NON-CONTINUOUS TEST
Non-
all tests
buttons,
57