G
E
T
T
Keypad zones do not support DEOL resistors.
Assigning Keypad Zones
When using keypad zone inputs, each input used must be assigned a zone number in Installer Programming.
First, ensure that you have enrolled all installed keypads into the desired slots. (See Section 2.6 "Keypad
Assignment").
Next, enter programming section [020] to assign the zones. There are eight programming locations in this
section, one for each keypad slot. Enter a 2-digit zone number for each of the keypad zones. This number must
be entered in the location corresponding to the keypad to which each zone is connected.
If a keypad zone input is assigned on zones numbered from 1 to 8, the corresponding zone cannot be
used on the main control panel.
Once the keypad zones are assigned, you must also program zone definitions and zone attributes. (See
also Section 5.1.1 "Assigning Keypad Zones").
I
N
G
12
S
T
A
R
T
E
D