Resetting Smoke Detectors - C&K systems System 236i User Manual

RESETTING SMOKE DETECTORS

OPTION
INSTALLED
When a smoke detector is triggered, the red ZONE light of the zone where it's
located will come on, and the bell/siren will sound.
Before you do anything else, evacuate the building. Don't go back
inside until you are sure it's safe. When it's safe to do so, you can reset
the smoke detectors by doing the following:
STANDBY BATTERY
OPTION
INSTALLED
Should there be a loss of AC power, the green POWER light on the keypad
will go out, and your alarm system will switch to its standby battery. If an AC
power failure lasts for more than 15 minutes, the system will send a signal to
the central station (if programmed to do so).
.
22
Push the key, enter the digit "6",
the digit "2", and push the # key.
The standby battery should be replaced every four to six years with a rechargeable
12 V 6.5 Ah sealed lead-acid battery (such as C&K Model 1265).
6 2