C&K systems System 236i User Manual page 26

STANDBY BATTERY TEST
OPTION
INSTALLED
Your alarm system can be programmed to automatically test its standby
battery every 24 hours. During the test, AC power is turned off in order to
monitor the battery under load.
.
To manually test the standby battery, push the
the # key.
.
The standby battery test takes 2 minutes. During the test, the POWER light will be off.
.
If the battery is okay, the keypad will beep twice.
If the battery is low or dead, the POWER light will flash slowly, the SERVICE light will be
on steady, and the keypad will beep five times.
OPTION
INSTALLED
BELL/SIREN TEST
To test the bells/sirens in your security system:
PIN
Enter your PIN (if required), push the
REQUIRED
digit "3", then push the # key.
.
The bell/siren and keypads will sound for 3 seconds.
26
key, enter the digit "6", the digit "4", then push
6
6
key, enter the digit "6", the
4
3