Table of Contents
Advertisement
Rev 1.0
Starting a WebUI Connection to the Switch
Step 1.
Set up an Ethernet connection between the switch and a local network machine ("the remote
machine" henceforth) using a standard RJ-45 connector.
Step 2.
Start a Web browse – Internet Explorer 7.0 or Mozilla Firefox 3.0.
Note: Make sure the screen resolution is set to 1024*768 or higher.
Step 3.
Enter as URL the following: http://<switch_IP_address>
where <switch_IP_address> is the IP address of the switch or its DNS name.
Step 4.
You will receive the login window for remote management of the switch.
Step 5.
Use admin for both the login (Account) and the password.
=>Products=>Switches=>InfiniBand Switch Systems=>IS5025/IS5030/IS5035
Resetting the Switch
On the connector side panel under the system LEDs is a reset button. This reset button requires a tool to be
pressed, a paper clip will do.
This button resets the switch when the button is pushed. A quick push of this button resets the whole
switch.When the button is held down for 15 seconds the switch is reset and the password is reset to the fac-
tory default password. The LEDs will flicker for a fraction of a second to indicate reset is occuring.
12
Mellanox Technologies
The MIS50XXSeries User Manual can be found at:
http://www.mellanox.com
Figure 3: Reset Button
Use an opened paper
clip to press the rest
button.
STATUS
PSU 1
PSU 2
FAN
RST
Hide quick links:
Advertisement
Table of Contents
