Overall Configuration Procedure For The Control Processor - Extron electronics IPL Pro Series Setup Manual

Overall Configuration Procedure for the Control Processor

Within Global Configurator
(GC Professional or
GC Plus mode):
Overall Configuration Steps
Figure 4.
If you have questions during installation and setup, you can call the
S3 Control Systems Support Hotline
Configure the IP settings of
the control processor and the
TouchLink Pro touchpanels.
Create a new GC Professional or GC Plus project
and add the control processor to it.
Will
TouchLink Pro or
third party touchpanels or
No
other user interfaces
be used?
Con gure ports on the
control processor.
Create monitors, schedules,
macros, and local variables.
Import GUI layouts, add touchpanels
or other interfaces (if used), and
con gure them.
Save the project.
Build and upload the con guration to
the control processor.
Test the system, make adjustments,
nalize con guration.
Extron S3 Sales & Technical Support Hotline
(1.800.633.9877).
See "Network "Network
Communication Communication
Setup"
Setup" in this
guide.
Yes
Create GUI layouts for the
touchpanels or other interfaces:
1. Start GUI Designer.
2. Create GUI layout designs for each
TouchLink Pro or third party
touchpanel (with a TouchLink
Interface), or for a computer or
mobile device (with LinkLicense).
3. Save and build the GUI layout le.
or the Extron
7