Adjusting Footplate Height; Spring Button Height; Bolt-In-Place Height - Invacare 9000 SL Owner's Operator And Maintenance Manual

Adjusting Footplate Height

Spring Button Height

NOTE: For this procedure, refer to FIGURE 4.2.
NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on
page 34.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to unlocked
position.
NOTE: The elevating legrest has two sets of
release buttons, one set above the other. Each set
will be visible one at a time allowing finer
footplate height adjustment.
3. Push in the release buttons and
reposition the footplate assembly to the
desired height.
4. Ensure that the release buttons fully
protrude from holes on both sides of
the front rigging support.
5. Rotate cam lock lever down to locked
position.
6. Repeat this procedure for the other
footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front
Riggings on page 34.

Bolt-In-Place Height

NOTE: For this procedure, refer to FIGURE 4.3.
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on
page 34.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to position.
3. Using a screw driver to hold the threaded rivet in position, remove the button head
screw from the threaded rivet.
4. Remove the threaded rivet and button head screw securing the footplate assembly to
the front rigging support.
Part No.1056953
SECTION 4—FRONT RIGGINGS
Adjustment
Holes
Cam Lock Lever
NOTE: Swingaway footrest shown.
FIGURE 4.2 Spring Button Height
35
Front Rigging Support
Release Button
Footplate
Assembly
9000 Series