Raising/Lowering Elevating Legrest Assembly - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
5. Adjust the footplate assembly height by aligning the desired adjustment holes in the
upper front rigging support and lower footplate assembly.
6. From the outside of the swingaway front rigging, insert the threaded rivet through
both the front rigging support and the footplate assembly.
7. From the inside of the swingaway front rigging, insert the button head screw through
the appropriate adjustment hole and thread into the threaded rivet.
8. Using a screwdriver to hold the threaded rivet in position, securely tighten the button
head screw. Torque to 32 in-lbs.
9. Rotate cam lock lever down to locked position.
10. Repeat STEPS 1-9 to adjust the remaining footrest.
Button Head
Screw
Adjustment
Hole
Cam Lock
Lever
Inside of
Swingaway
Front Rigging

Raising/Lowering Elevating Legrest Assembly

Ensure hands and fingers are clear of elevating legrest mechanism before pushing
release lever to lower the elevating legrest. Otherwise injury may occur due to
pinch points.
The wheelchair user's leg MUST be supported by an assistant before attempting to
lower legrest.
NOTE: For this procedure, refer to FIGURE 4.4.
9000 Series
Front Rigging
Support
Button Head
Screw
Threaded Rivet
Footplate
Assembly
Front Rigging
NOTE: Swingaway footrest shown.
FIGURE 4.3 Bolt-In-Place Height
WARNING
Front Rigging
Support
Adjustment
Hole
Outside of
Swingaway
36
Threaded
Rivet
Footplate
Assembly
Part No.1056953