Section 4-Front Riggings; Installing Swingaway Footrest Assembly; Adjusting Footplate Height - Invacare Transport Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
SECTION 4—FRONT RIGGINGS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise, injury or damage may result.

Installing Swingaway Footrest Assembly

NOTE: For this procedure, refer to FIGURE 4.1.
1. Turn the footrest to the side (open fostotplate is perpendicular to transport chair).
2. Install the hinge plates on the footrest onto the hinge pins on the transport chair frame.
3. Push the footrest towards the inside of the transport chair until it locks into place.
NOTE: The footplate will be on the inside of the transport chair when locked in place.
4. Repeat this procedure for the other footrest assembly.
5. To release the footrest, push the footrest release lever inward, rotate the footrest
outward.
FIGURE 4.1 Installing Swingaway Footrest Assembly

Adjusting Footplate Height

NOTE: For this procedure, refer to FIGURE 4.2.
1. Remove the swingaway footrest assembly. Refer to Installing Swingaway Footrest
Assembly on page 24.
NOTE: Lay the assembly on a flat surface to simplify this procedure.
2. Loosen, but DO NOT remove, the footplate mounting bolt until the footplate assembly
moves freely.
3. Reposition the footplate assembly to the desired height.
4. Securely tighten the footplate mounting bolt.
Transport Chairs
WARNING
Hinge Pins
Hinge
Plates
Footrest Release Lever
Swingaway Footrest
Assembly
24
Part No.1125095