Cleaning; Installing Crutch And Cane Carrier - Invacare 9000 SL Owner's Operator And Maintenance Manual

3. Telescoping I.V. Rod Holder Only - Secure the top of the telescoping I.V. rod holder to
the wheelchair frame with a tie wrap.

Cleaning

The user and O2 cylinder must be removed from the wheelchair when cleaning the
O2 holder. Otherwise, injury or damage may occur if cleaning agents come in con-
tact with the O2 regulator.
1. Remove the user, any I.V. medication and the O
2. The telescoping I.V. rod/O
3. After the cleaning solution has dried, it is safe for the user to re-occupy the wheelchair.

Installing Crutch and Cane Carrier

Check base weekly to ensure proper placement.
When loading the crutch/cane carrier, ensure items are securely placed into the
base. Also ensure that there is no interference with folding the wheelchair, the rear
wheels, or the swing-back arms.
Strap must be securely fastened while carrying items.
NEVER insert or remove items while wheelchair is moving.
NOTE: For this procedure, refer to FIGURE 11.2.
1. Slide the clamp with the base attached
over the end of the step tube of the
wheelchair. Ensure the base is towards
the inside of the wheelchair.
2. Position the base parallel to the step
tube.
CAUTION
Base should be parallel to step tube to
avoid bending spokes when folding the
wheelchair.
3. Securely tighten the locknut that
secures the base to the step tube of the
wheelchair.
4. Remove the upper back upholstery screw and washer.
Part No.1056953
WARNING
holders clean easily with any household glass type cleaner.
2
WARNING
FIGURE 11.2 Installing Crutch and Cane
71
SECTION 11—OPTIONS
cylinder from the wheelchair.
2
Strap
Base
Step
Tube
Clamp
Locknut
Carrier
9000 Series