Extreme Networks E4G Series Hardware Installation Manual page 77

6 Carefully slide the power supply all the way into the power supply bay
supply in until the latch snaps into place.
Figure 49: Installing a 300 W AC Power Supply
CAUTION
Do not slam the power supply into the router.
7 Connect the AC power cord to the input connector on the power supply and rotate the wire clip into
place over the power cord connector.
8 Connect the other end of the power cord to an AC power outlet.
WARNING!
Always be sure that the source outlet is properly grounded before plugging the AC power cord into
the AC power supply.
E4G Series Routers Hardware Installation Guide
Replacing an AC Power Supply in the E4G-400 Router
(Figure
SH_202
49). Push the power
77