Extreme Networks E4G Series Hardware Installation Manual page 39

CAUTION
Unshielded twisted pair (UTP) cable can build up ESD charges when being pulled into a new
installation. Before connecting any category 5 UTP cable to the router, discharge ESD from the cable by
plugging the RJ-45 connector into a LAN static discharge device or use an equivalent method.
Use plenum-rated cable when it is necessary for safety and fire rating requirements. Consult your
●
local building codes to determine when it is appropriate to use plenum-rated cable, or refer to IEC
standard 850.
Keep all ports and connectors free of dust.
●
Figure 13: Properly Installed and Bundled Cable for an E4G-400 Router
E4G Series Routers Hardware Installation Guide
Evaluating and Meeting Cable Requirements
CSR_028
39