Table of Contents
Advertisement
Installation New Construction:
The speaker brackets should be installed
prior to the drywall.
1. Attach the wings to the bracket by
snapping them into the sides of the
bracket. (See Figure 1). To shorten the
wings, break them along the scored lines.
2. The wings and brackets have centering
lines to simplify placement of the speaker.
3. Use a tape measure to locate and center
the brackets in the ceiling.
4. Mark each speaker location with a
pencil.
5. Screw one side of the assembled bracket
with wings to the joist using one of the
supplied screws.
6. Screw the other side of the bracket/wing
assembly to the joist. Two screws on
each side make for a very secure
installation.
7. Secure the wire to the bracket using the
bracket's wire tie.
4
Figure 3
Break away two of the outer
mounting tabs on the side
you wish to affix.
8. In unique situations where the bracket
must be located precisely next to a joist,
the bracket has "emergency" screw
holes located on its snap-on tabs. Break
away two of the outer mounting tabs on
the side you wish to affix, see Figure 3.
Notching the joist so the bracket lies
flush may be required.
9. Next, screw the bracket tab to the joist
using one of the supplied screws.
Important: Do not over-tighten the screw,
doing so could crack the bracket tab.
Level the bracket, then affix the other side
of the bracket assembly using the
supplied screws.
10. After the drywall is installed, cut a hole
in the drywall using the outside of the
circular bracket flange as a template.
11. Attach the frame to the bracket by
screwing the frame to the bracket using
the supplied screws. NOTE: Do not over
tighten the screws, this will distort the
frame and the grille will not fit.
Emergency
screw hole for
butting bracket
against
joist.
Advertisement
Table of Contents
