Table of Contents
Advertisement
Optional Equipment
Remote Thermostat
•
Follow the instructions included with the remote thermostat for installation.
Using the Remote Thermostat
The remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up and
the heater turns on. Included with the remote thermostat is a set of instructions that details the
operating characteristics of this optional component.
Pellet Log (part # 98900126)
1
Assemble the log shelf (with log shelf extender) following the directions below.
3
Remove the firepot from the pellet stove. Center the log shelf assembly (with extender attached)
over the burnpot holder. Replace the burnpot. Place the log on the log shelf extender.
Center the log on the log shelf and
b
push it back so it rests against
these two tabs.
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.
Travis Industries
Left Log Shelf Leg
Log Shelf Cross Brace
4 0 1 1 0 0 9
Right Log Shelf Leg
Nuts
3/8" Nutdriver
Place the log shelf assembly so the
a
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
9 3 5 0 8 1 2 6
3 7
Advertisement
Table of Contents
