2 2
Adjusting the Fan Speed
HEAT OUTPUT
E
E
FAN
Start-Up Sequence
This stove utilizes a start-up sequence whenever the mode switch is changed or the heater is started
when cold. This is to ensure proper operation through all possible settings and operational states (hot
or cold, pellets burning or not burning, etc.). This sequence over-rides all user settings (except the
"OFF" position) to set the auger feed rate to medium, the exhaust blower to high, and the igniter on.
"AUGER ON" Light
This light comes on when the auger is turning. This allows the operator to determine when the auger
is turning.
Travis Industries
Operation
Use the FAN dial to adjust the
convection blower speed.
AUTO
OFF
MANUAL
MANUAL
START
FAULT
4 0 1 1 0 0 9
9 3 5 0 8 1 2 6