Table of Contents
Advertisement
3 6
Thermostat (Part # 99300650)
!
Do not connect 120
VAC to the
thermostat circuit of
this heater (do not
use a household
thermostat used for
a wall-board or other
electical heater).
1
Attach the
thermostat wire to
the circuit board.
2
Determine a
location for the
thermostat that is
within range of the
50' length of
thermostat wire. It
should be
centralized in the
room and away from
the heater. The
wire may be routed
externally on the
wall or behind the
wall (preferred).
3
Cut the thermostat wire so there is approximately 6" of slack. Expose 1/2" off each wire of
the thermostat wire. Attach the exposed wire to the clips on the back of the thermostat
using a screwdriver.
4
Pull the cover off the thermostat. Place the thermostat in location and attach it to the wall
through the two obround holes (use the appropriate screws for the type of wall it is being
attached to). Replace the cover on the thermostat to complete the installation.
Travis Industries
Optional Equipment
Expose 1/2" of
wire and attach
to the two
connections on
the back of the
thermostat (use a
screwdriver).
Orientation does
not matter.
Back Side of
Thermostat
Pull the cover off the
thermostat to expose the
holes for mounting the
thermostat.
d
Wall
Use the appropriate screws to
mount the thermostat to the wall.
4 0 1 1 0 0 9
a
Open the hopper lid and remove the
screw holding the right panel in place.
Phillips
Screwdriver
Swing the
panel
open.
b
Attach the quick-connects on
the thermostat to the thermostat
posts on the circuit board
(orientation does not mater).
c
Thread the thermostat wire
through the hole in the rear panel.
Pull on the thermostat wire to allow just enough
slack to allow the right side panel to open.
Run the thermostat
wire through the
wall (cut off
excess wire,
leaving 6" of slack)
9 3 5 0 8 1 2 6
Advertisement
Table of Contents
