Table of Contents
Advertisement
Auto Mode
Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns
on when the temperature drops below the thermostat setting. Once the stove reaches operating
temperature, the stove then runs at the heat output setting selected.
To Adjust Room Temperature (or
Start the Stove)
Move the thermostat to the heat setting
desired. If the room is cooler than the setting,
the stove will go through the start-up
sequence for approximately 10 minutes. Once
up to temperature, the stove will then run at
the heat output setting selected on the control
panel. If the room is too hot, move the
thermostat to a lesser setting.
To Adjust the Heat
Adjust the "Heat Output" dial to meet the
heating requirements you desire.
NOTE:
If you find that the stove turns on and off
repeatedly, you may wish to turn the heat
output to a lesser setting. The lower setting
will provide a more consistent heat output over
time, eliminating the need for the thermostat to
repeatedly turn the stove off.
NOTE:
If the thermostat calls for heat while the stove is
still cooling down, the stove will go through the
start-up sequence.
To Shut Down
Move the mode switch to "OFF". The exhaust
blower will still run until the heater cools down.
Travis Industries
Operation
4 0 1 1 0 0 9
H
E
HIGH
AUTO
A
T
MANUAL
O
MED
U
T
P
AUGER
U
LOW
ON
T
HEAT OUTPUT
E
AUTO
OFF
MANUAL
E
MANUAL
START
FAN
FAULT
HEAT OUTPUT
E
AUTO
OFF
MANUAL
E
MANUAL
START
FAN
FAULT
2 1
These lights
indicate the
heat output
setting.
9 3 5 0 8 1 2 6
Advertisement
Table of Contents
