Procedure 2.2 - Accessing The Information Display Program - Precor 9.55 Manual

Procedure 2.2
The information display will access the following data;
• Odometer
• Hour meter
• Software version
• Error log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
Press the keys RESET,6,5, sequentially.
2.
The display will momentarily read, DIAGS - INFORMATION DISPLAY.
3.
The display will momentarily read, ODOMETER.
4.
The treadmill's odometer will be displayed as 1234567 MPH or 1234567 KPH.
5.
Note:
The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
Press the ENTER key to proceed to the hour meter display.'
6.
The display will momentarily read, HOUR METER.
7.
The operating time of the unit will be displayed as 12345 HOURS. The operating time is
8.
defined as total amount of time that the unit has operated in program modes with the drive
motor running. The hour meter is also used to provide the "time stamp" for the error code
log.
Press the ENTER key to proceed to the software version display.
9.
10. The display will momentarily read, SOFTWARE VERSION.
11. The software versions of the upper and lower PCA's will be displayed as;
UPPER 1.01
12. Press the ENTER key to proceed to the error log.
- Accessing the Information Display Program
LOWER 1.01.
9.55 Treadmill
Page 7