Procedure 2.1 - Accessing The Hardware Validation Program - Precor 9.31 Service Manual

Procedure 2.1 - Accessing the Hardware Validation Program

The treadmill's diagnostic program consists of the following modes:
• Display Test
• Keyboard Test
• Heart Rate Test
• Lift Test
• Belt Speed Test
• Belt Power Test
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
Press keys RESET,5,1,7,6,5,7,6,1, sequentially.
2.
3. If you are testing a 9.33 or 9.35 treadmill continue with step 4. If you are testing a 9.31
treadmill skip to step 31.
4. The keys on the display are hypothetically numbered 1 to 7 from left to right. See Diagram
2.1. The STOP is key number 4 and is located directly below the QUICK START key. The
QUICK START key is not part of the numbering sequence.
The display will momentarily read DIAGS - HARDWARE VALIDATION.
5.
The display will momentarily read DISPLAY TEST and then illuminate every LED on the
6.
display. Check all LED positions to ensure that all of the LED's are functioning. Press the
ENTER key to continue.
Diagram 2.1 - 9.33 & 9.35 Displays
9.31, 9.33, 9.35 Treadmill
Page 4