Memory Mode (Scanning Versions Only); Second Channel Mode - Simrad RT62 Instruction Manual

2.4 Memory Mode

2.5 Second Channel Mode

E04074
This function is only available on scanning versions of the
VHF. It allows the radio to operate using only the channels
programmed into the channel memory. Press F then press
SCN, holding down for 2 seconds. Rotating the channel select
knob will then only select the channels programmed into the
memory. To disable this mode and return to normal operation,
either switch the radio off and on again, or press 16.
This mode will only be available if there are channels pro-
grammed into the memory (see section 2.2.2).
In countries where it is permitted, holding F/
turning the radio on will enable the radio to operate on a sec-
ondary set of channels - normally the USA channels (Fig 2.8).
POWER
Fig 2.8 - Selecting secondary channel set
The display will show USA for USA channels, CAN for
Canadian channels etc. Channel sets available will vary
depending on which country the radio is programmed for use
Instruction Manual
down while
ON
15