Download Print this page

JL Audio Stealthbox SB-N-MURAN/10W1v2 Installation Manual page 3

2003-up nissan murano

Advertisement

Cont.
From
Previous
Page
STEP 15: a) Lower the flooring back into position,
from STEP 2.
b) Place the driver's side floor cargo pocket panel
back into place. Pick up the left side of the panel
and stand it up on it's right edge, just right of the
pair of the round dual lock fastener. As shown in
the picture above.
c) Mark the under side of the floor panel, of the
location of the round dual lock fastener.
Specifications:
Enclosure Type: Sealed
Driver Type: 10W1v2-4
Nominal Impedance: 4
Cont. Power Handling: 150Watts
JL Audio recommends using a high quality amplifier such as the JL Audio e2150. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the e2150 when being used to power your Stealthbox®.
The JL Audio e2150 is a very versatile audio component. Please consult the owner's manual for detailed information
about installing and tuning this amplifier.
w w w . j l a u d i o . c o m
1-1/2"
STEP 16: a) Flip over the side floor panel.
Measure 1-1/2" from the outside left edge to the
right.This measurement needs to line up with the
round dual lock fastener position markings
made in STEP 15. Mark the final location.
b) With the pair of supplied round dual lock fasten-
er and the pair of #6x3/8" Phillips® screws. Mount
the round dual lock fastener to the under side of
the floor panel at the markings.
10369 N. Commerce Pkwy, Miramar, Florida 33025-392
S B - N - M U R A N / 1 0 W 1 v 2 , J L AU D I O, I n c 2 0 0 6
STEP 17: Snap the driver's side rear cargo pocket
cover into place.
Mid/High Frequency Driver Information:
Front Location Driver Size:
6x9
Applicable JL Audio Products:
TR690-TXi & VR650-CXi
Rear Location Driver Size:
6.5"
Applicable JL Audio Products:
TR,VR & XR650-CXi
Phone: 954.443.1100
Pa g e 3
CONGRATULATIONS!
INSTALL COMPLETE.
Included Hardware:
1) 1/4" USS Flat Washer
1) 3/8"-16x1-1/4" Hex Bolt
2) 3/8" Split Lock Washer
2) #6x3/8" Philip® Head Screws
1) 3/8"-16x1-3/4" Hex Bolt
3) 3/8" Flat Washer
1) 3/8" x 1-1/4" Fender Washer
1) 2"x1-1/4"x1" 3-Hole L-Bracket
1) 3/8"-16 Hex Nut
1) 8mmx35mmx1.25" Hex Bolt
2) Round Dual Lock Fastener
Difficulty Of Installation:
VR690-CXi
VR650-CXi
Fax: 954.443.1111
S h e e t S K U # 0 1 1 1 9 7 R ev i s i o n 1 / 1 8 / 2 0 0 6

Advertisement

loading

This manual is also suitable for:

Stealthbox vr690-cxi