Operating Procedure; Electronic Control - Star FS1R Installation And Operation Instructions Manual

OPERATING PROCEDURE

Connect your unit to a wall outlet which will supply the unit with the proper voltage specified on the data
plate. If you have a reservoir unit, verify the water level, add if water is low.
CAUTION
KEEP HANDS AND FACE AWAY FROM THE UNIT WHEN OPENING OR REMOVING THE
SPATULA FROM THE UNIT. STEAM ESCAPING IS VERY HOT.
MANUAL CONTROL
• Turn unit on
Wait 20 - 0 minutes for the unit to reach its operating temperature before using.
Note: The Temperature Set Point is factory fixed at 400°F (204°C) and is not adjustable.
• Place product in cooking chamber and hit the Steam Shot button to steam the product.
Steam Shot:
Pressing the Green Steam Shot Green Button will release water in to the steam generator
and will instantly produce steam. Water will only stop when the button is released. Flooding of the
steam generator may occur if the Steam Shot button, or the SST is set to high. When this occurs wait
for the unit to work through the water before applying more water
to the steam generator.

ELECTRONIC CONTROL

• Turn unit on
Current Temperature will Flash on LED, PRESS the
TEMP button to see current temperature
TCT will FLASH until TSP (Temperature Set Point) is reached,
Alarm will sound -times when TSP is reached.
Note: The Temperature Set Point is factory fixed at 400°F (204°C) and is not adjustable.
• Place product in cooking chamber and choose one of the 4 pre-determined programmed
settings, or hit the Steam Shot steam button to steam the product.
• When program timing is completed, an alarm will sound.
Steam Shot:
Pressing the Green Steam Shot Button will release water in to the steam generator and
will instantly produce steam. Water will only stop when the button is released. Flooding of the steam
generator may occur if the Steam Shot button, or the SST is set to high. When this occurs wait for the
unit to vaporize all of the water before applying more water to the steam generator.
TIMER & STEAMER CONTROLLER OPERATION SPECIFICATIONS
Startup:
1. The preset time will flash until the operating temperature is reached.
2. When the control reaches preset temperature, time display, "Heat On" indicator and program
indicator will stop flashing and the alarm will beep three times.
Temperature:
. To view the actual steam generator temperature, press and hold "Temp Button."
7
PROGRAMMING DEFINITIONS
TCT Total Cook Time
SIT Shot Interval Time
SST Steam Shot Time
TSP Temp Set Point