Hitachi C 10FCH Technical Data And Service Manual page 19

(1) Setting to cut crown molding at positions
Turn the turn table to the right and set the miter angle as follows:
1
For 45û type crown moldings: 35.3û ( mark)
For 38û type crown moldings: 31.6û ( mark)
Turn the head to the left and set the bevel angle as follows:
2
For 45û type crown moldings: 30û ( mark)
For 38û type crown moldings: 33.9û ( mark)
Position the crown molding so that the lower surface (
3
Fig. 20.
(2) Setting to cut crown moldings at positions
Turn the turn table to the left and set the miter angle as follows:
1
For 45û type crown moldings: 35.3û ( mark)
For 38û type crown moldings: 31.6û ( mark)
Tilt the head to the left and set the bevel angle as follows:
2
For 45û type crown moldings: 30û ( mark)
For 38û type crown moldings: 33.9û ( mark)
Position the crown molding so that the lower surface (
3
Fig. 21.
1
Miter angle scale
Turn table
Fence
A
and
1
2
Head
Bevel angle scale
4
Fence
Base
Fig. 18
B
Table on base
Fig. 20
in Fig. 17 (See Fig. 18, tilt the head to the left.):
4
in Fig. 16) contacts the fence as indicated in
A
and in Fig. 17 (See Fig. 19, tilt the head to the left.):
3
in Fig. 16) contacts the fence as indicated in
B
2
Fence
Fence
B
--- 15 ---
Head
Bevel angle scale
3
Base
Turn table
Miter angle scale
Fig. 19
A
Table on base
Fig. 21