Internal Chassis Layout; Tools And Supplies Needed; Cautions; Figure 21. Ibm ® Xseries 343 Server (Shown With Top Cover And Bezel Removed) - IBM @server xSeries 343 Product Manual

Internal Chassis Layout

®
The IBM
contains connectors for installing up to two Intel
the FCPGA sockets. The baseboard has 6 DIMM slots and supports up to 12 GB error checking and
correcting (ECC) SDRAM memory. The IBM
6 PCI slots (implemented via riser cards), input/output (I/O) ports and various controllers.
A. Power Supply
B. PCI card bracket (full-length)
C. Riser card assembly (full-length)
D. PCI card bracket (low-profile)
E. Server Baseboard
F. PCI add-in card (accessory to system)
G. Riser card assembly (low-profile)
Figure 21. IBM

Tools and Supplies Needed

•
Jumper removal tool or needle-nosed pliers
•
Small flat-headed screwdriver
•
Phillips* (cross head) screwdriver (#1 bit and #2 bit)
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Heat Sink Clip Attach/Removal Tool

Cautions

These warnings and cautions apply throughout this chapter. Only a technically qualified person
should configure the server board.
CAUTIONS
System power on/off: The power button DOES NOT completely turn off the
system AC power; 5 Volt standby is still active whenever the system is plugged
xSeries 343 Product Guide
xSeries 343 server uses the Telco and Industrial Grade system baseboard, which
B C
A
®
xSeries 343 server (shown with top cover and bezel removed)
®
Xeon™ processors with 512 KB L2 cache utilizing
®
xSeries 343 server baseboard also contains
D
F
E
G
M L K
H. System Fans
I. FPIO system board
J. RJ-45 COM2 and Dual USB ports
K. Control Panel
L. SCSI Hard Disk Drive Bays
M. Peripheral bay (optional CD-ROM
module or FDD module available)
H
I
J
TP00485
87