Front Panel; Back Panel - Speco NVRP4 User Manual

Front Panel

1.2
Name
(1) NVR Power LED
(2) HDD LED
(3) IR Sensor
(4) USB 2.0 Port
(5) Network 1 Indicator
(6) Network 2 Indicator

Back Panel

1.3
Name
(1) 2 x USB 2.0 ports
(2) VGA Out
(3) Audio In/Out
(4) Sensor In
(5) Alarm Out
(6) Gigabit LAN 2 port
(7) e-SATA port
(8) Gigabit LAN 1 port
(9) Power button
(10) 12V DC
(11) Clamp hole
(12) Lock hole
Function
Light when the unit is power on
Indicate the hard disk running state. Light is on when the HDD is running
(Read/Write)
Receive signal from the remote control to operate the unit
For flash drive/DVD-ROM connection
Indicate the status of network 1 (Port LAN 1)
Indicate the status of network 2 (Port LAN 2)
Function
For USB keyboard, mouse, and other USB device connections.
Output the video signal to a CRT or LCD monitor
- Audio In: Input the audio signal from audio input device such as microphone
- Audio Out: Output the audio signal to a audio out device such as speaker
i
The audio input/output device has its own power supply where necessary.
Support 4 sensor devices
Support 1 relay device (Relay: 1A @ 125VAC / 30VDC)
To connect the switch of your network for internet connection, remote accessing,
-
and connection of IP camera.
LAN 2 support Static, DHCP, or PPPOE mode.
-
For connecting external RAID
LAN connection only but default assign as a DHCP service port. User also can
-
connect the IP camera through the Ethernet cable.
LAN 1 supports Static or DHCP mode.
-
Press it to power on the NVR unit.
Power cable connection
For clamp plug-in to clamp the power cord (see
For locking the NVR unit to avoid NVR unit been taken.
Chapter
2
1.4.2.1)