Setup The Ip Ptz Camera - Speco NVRP4 User Manual

2.2.2.1

Setup the IP PTZ Camera

When IP PTZ camera has been successfully connected to the NVR system, user can use the PTZ
function directly without any configuration. To make connection of IP PTZ camera, please refer to
3.2.1.
In PTZ camera panel, user can setup the preset position of the camera. The number of preset positions is
dependent on the IP PTZ camera that the user has connected. User can refer to the user's manual of the
IP PTZ camera to find out the number of the preset positions that are supported.
Please follow the below steps to configure the preset position.
1. On Preview User Interface, select the channel that is an IP PTZ camera connection.
2. Click PTZ button from Preview User Interface and PTZ control panel will show up.
3. In the PTZ control panel, using the arrow button to adjust the position of IP PTZ camera.
4. And then, click Setup (see also
5. Select the Preset Number to assign a number for the PTZ camera current position. And then, click
Save to save the setting.
6. Set the DwellTime for how long the PTZ camera stays in that position before it moves to the next
one.
7. Repeat step 3 to 6, if you want to save another preset position.
8. Restore AutoPan Time: set a time period for restoring auto path function after the PTZ camera has
been moved manually. Mark the check box and set the time period in second.
9. Click OK to complete the setting.
Chapter 2.2.2). The Preset Settings window will show.
12
Chapter