Network Setup - Speco NVRP4 User Manual

4 channel network video recorder
Hide thumbs Also See for NVRP4:
Table of Contents

Advertisement

Network Setup

3.4
Click on Default to revert to the factory default values.
(1) Server Name
Assign a name for the NVR unit. Alphabetical and numerical letters only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section to enable each camera to be
accessible via internet using WebViewer, Remote Console, CM3000(Gold),PDA Viewer and JavaViewer
(still image). To select all the cameras, enable the ALL check box.
(3) Main Configuration
Set the NVR IP address and Remote Console Port. This is required for accessing NVR server from a
remote location via internet.
The NVR system supports dual LANs; user can select the Server IP from the drop-down list and click
Setting to configure the details. The dual LAN ports balance network bandwidth to avoid network traffic
congestion.
The default IP of the NVR server is 192.168.2.2 for LAN1 (lower LAN port in the back of the NVR) and
i
-
192.168.3.2 for LAN2 (upper LAN port in the back of the NVR).
LAN1 can be set as Static or DHCP mode and supports only for LAN connection.
-
LAN2 can be set as Static, DHCP, or PPOE mode and supports both WAN and LAN connections.
-
Both LAN ports cannot be configured in the same LAN segment; this will cause network connection
-
failure.
When only using port LAN2, please set IP address of port LAN1 in different LAN segment from port
-
LAN2.
32

Advertisement

Table of Contents
loading

Table of Contents