Setup - Network Mode - Speco N32NS User Manual

Item
OSD
OSD Contrast
Main Monitor
Sequence
Sequence Dwell
Time
Site
Name Set the channel name. Press the right square button and set the channel
Covert Enable/disable display of the specified video channel in live display.
Video Output
4-6. Setup – Network Mode
Select the Network tab. Then, the network menu is displayed as pictured below. Navigate through the menu
items or change the settings using the mouse or the remote control.
Table 4.5.1. Menu Items in Display Setup Screen
Enable/Disable on-screen-display.
(Channel Name, Video Loss, Status Bar / Icon)
Set the visibility level of the On Screen Display (OSD) (0~100)
Enable/Disable sequential display of video in full screen mode.
Set the dwell time of each,
single channel display in sequential display mode (3~60 seconds)
Select a channel to apply the name and covert settings change using the
mouse or the remote control.
Select a channel to apply the following settings using the mouse.
name and select OK using the mouse.
The name can be made up to 36 characters.
Select 1280x720 or 1920x1080. 3840x2160 supports for only N32NS.
Figure 4.6.1. Network Setup Screen
Description
46