Windsor Expert Instructions Manual page 17

TROUBLESHOOTING CHART
PROBLEM
Brush Not Turning
Worn Bearings
Carpet Not Getting
Clean
Carpet Too Wet
Carpet Not Getting Wet
CAUSE
Belt broken.
Faulty switch.
Faulty circuit breaker.
Faulty brush motor.
Squealing or grinding sound in brush
housing.
Severe soil conditions
Worn spray jet(s)
Solution filter screen clogged.
Spray jet(s) clogged.
Pump not running.
Solution valve adjustment.
EXP 98363 08/25/04
SOLUTION
Remove belt cover on right side of
machine.
Inspect belt.
Replace if necessary.
Replace.
Replace
If the belt, circuit breaker, and switch
have been tested and found to be in
good working order, the brush motor
may need to be replaced.
Replace bearings.
Make several passes at right angles to
each other.
Use a pre-spray.
Replace spray jets which are producing
more than a fine mist.
Clean solution filter screen located
inside lower tank near the front.
Clean or replace jets. Do not use a
wire to clean jet. Damaged jets will
cause over-saturation.
Check for and correct any loose wires.
Repair or replace.
Adjust solution valve cable until valve
operates when handle is pulled.
Align slit in jet parallel with center line
of brush.
4-7