Setting Up The Digital Imager Scanner; Installing The Interface Cable; Removing The Interface Cable - Symbol DS6707 Product Reference Manual

1 - 3 Symbol DS6707 Digital Imager Scanner Product Reference Guide

Setting Up the Digital Imager Scanner

Installing the Interface Cable

Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle.
1.
(See Figure 1-2.)
Gently tug the cable to ensure the connector is properly secured.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
3.
connections).
Clip
Installing the Cable
Figure 1-2
NOTE Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Connectors vary from those illustrated, but the steps to connect the digital imager scanner
remain the same.

Removing the Interface Cable

Using the tip of a screwdriver, depress the cable's modular connector clip.
1.
Removing the Cable
Figure 1-3
Carefully slide out the cable.
2.
Follow the steps for
3.
Cable interface port
Interface cable modular
connector
To host
Installing the Interface Cable to connect a new cable.