Chapter 5 Imaging Preferences; Introduction - Symbol DS6707 Product Reference Manual

Chapter 5 Imaging Preferences

Introduction

If desired, program the digital imager scanner to perform various functions, or activate different features. This
chapter describes imaging preference features and provides the programming bar codes for selecting these
features.
The digital imager scanner ships with the settings shown in the
5-2 (also see Appendix A, Standard Default Parameters
default values suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the digital imager scanner is powered down.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. (See
Chapter 7, USB Interface
upon the first power-up when connected to a new host.
To return all features to default values, scan the
bar code menus, default values are indicated with asterisks (
*
and Chapter 8, RS-232 Interface
*
Enable Decode Aiming Pattern
Indicates Default
Imaging Preferences Parameter Defaults on page
for all host device and miscellaneous defaults). If the
for specific host information.) This is only necessary
Set Default Parameter on page
*
).
(02h)
Chapter 6, SSI Interface,
4-4. Throughout the programming
Feature/Option
Option Hex Value
for programming
via SSI command