Connecting Cables - TANDBERG 3000 MXP Profile User Manual

2.2 Connecting Cables

All cables needed for a standard configuration are already connected to the codec. Connect
these cables to their respective parts of the system.
1. Power cables
Connect the power cable to an electrical distribution socket.
2. Monitor cables
Connect the DVI cable to the input on your monitor.
3. Microphone cables
Connect the microphone cable to the microphones.
4. Camera cable
When installing the Precision HD Camera, please follow the instructions in the enclosed
Installation Sheet for TANDBERG 3000 MXP Profile. Installation Sheets are also found on the
User Manuals CD.
NOTE! The enclosed TANDBERG Camera Cables must be used! Do not use other camera
cables as this might cause problems with the transfer of video signals from the Precision HD
Camera.
If you have a WAVE II Camera: Connect the camera cable labeled "Main Cam" to the S-Video
connector on the camera. Connect also the control cable labeled "Camera Control" between
the RJ-45 on the camera, and the Camera Port on the codec.
5. PC cable
Connect the PC cable to the PC.
6. ISDN cables
Connect the ISDN cables to the ISDN sockets (S/T interface) provided by the network provider.
The main ISDN number will be that number associated with the socket to which ISDN cable
number 1 has been connected.
Note! The system does not have a built-in network terminator. If wall socket provides an
ISDN U-interface, an NT1 between your system and the ISDN line is needed, see
10 for more information.
7. LAN cable
To connect the system to a Local Area Network (LAN), connect the cable labeled "LAN
Ethernet" to a suitable Ethernet port on the LAN.
Installation
Appendix
13