Camera Port - TANDBERG 3000 MXP Profile User Manual

6.1.5

Camera Port

The Camera Port can be used by both Precision HD Camera and Wave II Camera and has
different pin-out scheme for the different use.
6.1.5.1 Using Precision HD Camera
The TANDBERG 3000 MXP Profile* system is shipped with a PC cable with integrated audio.
See chapter: Interfaces – Video for more information about the camera cable.
NOTE! The enclosed TANDBERG Camera Cables must be used! Do not use other camera
cables as this might cause problems with the transfer of video signals from the Precision HD
Camera.
Pin-outs for the camera port when using the TANDBERG Precision HD Camera:
Signal name
Signal ground, GND
Receive data, RXD
Transmit data, TXD
Power, +12V
Signal ground, GND
Video LVDS +
Video LVDS -
6.1.5.2 Using WAVE II Camera
The TANDBERG 3000 WAVE II Camera cable consists of two cables, VIDEO CABLE and
DATA/POWER CABLE connected together at one end with DSUB CONNECTOR.
VIDEO CABLE
• Length 1900mm
• S-VIDEO connector
DATA/POWER CABLE
• Connector RJ45, 8 pin shielded modular jack
• Cable Twisted pairs 4-5, 3-6, 1-2, 7-8 color black
• Length 1920mm
VIDEO CABLE DATA/POWER CABLE connected at one end to DSUB CONNECTOR.
DSUB CONNECTOR
• Male 9 pin DSUB
Direction Pin number
From DCE
To DCE
To DCE
To DCE
Peripheral Equipment
1
2
3
4
5
6
9
231