Fastening The Heater On A Wall; Installation Capillary Tubing And Bulb; Safety Railing - Harvia KV-45 Instructions For Installation Manual

3.2. Fastening the Heater on a Wall

1. Fasten the wall-mounting rack on the wall by using
the screws which come with the rack. Observe the
minimum safety distances given in table 1 and fig. 5.
The fastening of the mounting rack is shown in figure 6.
NOTE! There should be a support, e.g. a board, behind
the panel, so that the fastening screws can be screwed
into a thicker wooden material than the panel. If there
are no boards behind the panel, the boards can also be
fastened on the panel. See figure 4.
2. Lift the heater onto the rack on the wall so that the
ends of the fastening bars go into the holes in the
bottom of the heater and the connecting box switches
are easily accessible.
3. Fasten the upper part of the heater to the
wallmounting rack by using the fastening clamp.
4. The steam distributor must always be fastened on
the wall side of the heater. To turn the distributor,
loosen the fastening screws and then turn it. See
figure 9.

3.3. Installation capillary tubing and bulb

Before hooking up electrical wires to junction box
of heater, remove capillary tubing and bulb from
junction box and bring up wall to left or right side of
heater. Cover tubing with wooden molding provided,
coil up excess tubing, and place under heater close
to floor.
Be sure to cover thermostat bulb with protective
metal cover by threading bulb through holes in cover,
and fasten bulb cover to wall with screws provided.
Also, take care when nailing protective wood strips
over capillary tubing, so that nails do not puncture
tubing. If punctured, entire thermostat must be re-
placed. See figure 7.

3.4. Safety Railing

If a safety railing is built around the heater, the mini-
mum distances given in fig. 8 must be observed.
Figure 7. Installation of the thermostat sensor
8.
Model D min D* min
inch inch
5/16
KV-45 4
KV-60 4 15/16 7 11/16
7/8
KV-80 4
Model D min D* min
m m m m
KV-45 110
KV-60 125 195
KV-80 175
D* Connection box against
the wall
Figure 6. Location of the mounting
rack of the heater
Figure 8. Safety railing of the heater
Figure 9. Connections and parts
of the heater